Misc.

Ever need to send power from your receiver to more pieces of gear than you have available connections? Maybe this can help! Want to be able to turn these outputs on and off all at once? Order it with the toggle switch option! Need a different size? Just ask. Send me a message to me at: mostlyal @ gm...

A part I have been meaning to introduce for some time now. It's very simple, but I think it might prove helpful on your next build. This is an easy way to get a battery power feed that you can turn on and off with a simple to mount toggle switch. It could be used to power your lighting for those times...

Operate a winch and two light circuits all without using up any channels on your transmitter! Choose the output power option for the winch controller. Either normal where the power to the winch is switched instantly, or Soft Start where the power to the winch ramps up over about 1/2 a second. The soft-start...

Do you have a few items that need to connect to JST? This product can help keep your wiring tidy. Choose 2, 3 or 5 output versions.

If you have crawled for a while and noticed your steering is weaker than you think it should be, it might be due to the often weak BEC that is included in most electronic speed controls. One fix for that is to run an external BEC. Sometimes you don't have the time or equipment needed to solder in an...

This is a remote control relay that is operated by a two-position channel. It is super easy to use, just plug it into a two-position channel to control it. Connect it to your power and load with either screw terminals or pig-tale leads.

This part will let you keep using your stock battery from your TRX4M when you have upgraded your ESC as long as your ESC is expecting a JST connector. Order it with or without a balance connector.

This controller provides you with a back up alarm and if you choose it at time of purchase, a reverse light output or a reverse light and brake light output, This controller works with ESCs that operate using "instant reverse" also called "crawler reverse". Not with the double pump reverse ESCs. See...

Makes your two-position channel-controlled servo run slower and have endpoint adjustments. This device connects between a servo and a receiver. The outer pots set the end points (where the servo stops). The center pot sets how fast the servo can move.

This device features a speaker that watches the servo signal that raises and lowers your truck It plays either an air compressor sound or an air escaping sound to simulate a set of airbags operating. It is meant to be used with a two-position channel (for up/down). The servo slower product can be used...